INSTALLATION GUIDE
Let’s get these stickers stuck!
The most important part of fitting any sticker to your car is the prep work!
If the surface isn’t clean & dry the sticker won’t stick the best.
DO NOT use window cleaners or any ammonia based cleaners.
ONLY USE water with a drop of dish soap to clean the application area.The best application tool is a Squeegee applicator with a felt edge, however you can also use a bank card wrapped in a microfibre cloth.
STEP 1
Clean the surface with water and a drop of dish soap. Ensure the application area is 100% dry.
STEP 2
Prepare the sticker by firmly rubbing a squeegee over to ensure all the sticker is stuck to the transfer tape.
This should also remove any bubbles that may have appeared.
STEP 3
Flip the sticker over and peel away the backing paper. If any of the sticker becomes stuck and stays on the backing paper repeat step 2.
STEP 4
Carefully apply the sticker to the intended area and rub over it with the squeegee, working from the middle outwards.
STEP 5
Slowly peel away the transfer tape at a 45° angle. Peel slowly making sure the sticker doesn’t lift from the surface.
STEP 6
Done! Step back and admire your new sticker!
Don’t forget to tag us on socials ‘@CERTIDecals‘ and use our hashtag ‘#certidecals‘